Burst pipe and mold cleanup in Coral Gables, 33134
Coral Gables houses from the 1920s onward carry barrel-tile roofs, plaster walls and older plumbing, so a split pipe or slow roof leak can soak deep into the structure and feed mold.
We drive southwest from Brickell to Coral Gables for burst pipes, roof leaks and the mold that follows them. The work is planned around what the house is made of, because a Mediterranean Revival home with plaster walls dries very differently from a newer condo near Miracle Mile.
At a glance
- Area
- Coral Gables
- From our office
- 1428 Brickell Ave, Floor 3
- Phones
- Answered 24/7
- Most calls
- Burst Pipe Water Damage
We cover all of Coral Gables, including the waterfront around Cocoplum and the condos downtown. Most of our calls here are burst or failed pipes, roof leaks under old tile, and mold behind plaster or in closets. Phone (786) 947-0034, day or night. We ask about the house and the water, then send a crew.
Merrick's Mediterranean houses and what they are made of
Coral Gables was incorporated on April 29, 1925, and George Merrick's plan required Mediterranean Revival architecture. That means stucco, barrel-tile roofs, old plaster and wood framing across much of the city, with waterfront estates in Cocoplum and along the Coral Gables Waterway and condos near Miracle Mile.
These materials are handsome and stubborn. Plaster holds moisture far longer than drywall, and older wood framing drinks it in. We dry them in place wherever readings allow, because tearing out original plaster is the last thing an owner here wants.
Where Coral Gables homes take on water
Aging tile roofs, older supply lines and original drain pipes are the most common indoor sources we see. A pipe that lets go inside a wall or ceiling can wet plaster, framing and wood floors well before anyone hears it.
Outside water matters too. The city counts over 42 miles of coastline and waterways, and Irma's surge reached about 6 feet near Matheson Hammock Park in 2017. Heavy rain on May 26 2020 flooded even the higher parts of the city, put Granada Golf Course underwater and left nearly a foot of water on some streets.
How a burst pipe job runs in an older Gables home
First the water gets shut off and the standing water comes out. Then we map moisture through plaster, framing and flooring with meters and thermal imaging, since wet plaster often looks dry on its face.
Drying older materials takes patience: dehumidifiers, controlled airflow and daily readings until each wall reaches its dry standard. If mold has started, we contain the area and remove it, and any lab testing is arranged through an independent assessor. Condo jobs downtown are coordinated with building management.
Other places near Coral Gables we serve
Crews working in Coral Gables also cover South Miami, Coconut Grove, Pinecrest, Westchester and Coral Terrace. Several of these neighborhoods have their own stock of older roofs and plumbing, so the same careful drying applies.
One phone line covers all of them: (786) 947-0034. Tell us the street, how old the house is if you know, and where the water showed up.
Where water and mold start in Coral Gables
Plaster holds moisture
Original plaster and wood framing stay wet behind a dry-looking surface, and that hidden dampness is where mold tends to start after a leak.
Old barrel-tile roofs
Aging tile roofs on older homes can let water into the decking and ceilings below long before a stain appears inside.
Waterfront surge exposure
With over 42 miles of shoreline and waterways, the southern waterfront faces surge and king tides. Irma put about 6 feet of water near Matheson Hammock.
Flooding on high ground
The May 2020 downpour showed that even the higher parts of the city can flood, with nearly a foot of water on some streets.
Services we run most in Coral Gables
Burst Pipe Water Damage
Split supply lines and failed fittings, from shutoff to dry-out.
See the serviceRoof Leak Water Damage
Wet ceilings, insulation and walls under a leaking roof dried and repaired.
See the serviceMold Removal
Containment, removal and cleaning of mold, with the moisture source fixed.
See the serviceWall & Drywall Mold Removal
Mold inside wall cavities and on drywall faces cut out and cleaned.
See the serviceHardwood Floor Drying
Cupping wood floors dried in place with floor mats when they can be saved.
See the serviceLeak Detection & Moisture Mapping
Thermal imaging and meters to trace hidden water inside walls and floors.
See the serviceCoral Gables: questions we hear
Can you dry plaster walls in a historic Coral Gables home without tearing them out?
Often, yes. Plaster can usually be dried in place with dehumidifiers and directed airflow, though it takes longer than drywall. We only recommend removal when readings stay high, the water was contaminated, or mold has taken hold behind it.
A pipe burst in my Coral Gables house while I was away. What should I do first?
Shut off the main valve if you can reach it safely, turn off power to any wet rooms, and call (786) 947-0034. Take photos before anything is moved. We extract the water, map where it traveled and start drying on the same visit.
Is mold common after roof leaks in Coral Gables?
It is a frequent follow-on. Water from an old tile roof often wets decking, ceilings and wall tops slowly, which gives mold time to grow before anyone sees a mark. We trace the wet area, remove growth under containment and dry the structure behind it.
Do you work on Coral Gables condos near Miracle Mile as well as houses?
Yes. Condo jobs follow the building's rules for elevators, parking and work hours, and we document each affected unit separately. The drying and mold work itself follows the same process we use in single-family homes.
Other places our crews cover
Water damage in Coral Gables? Call our crew lead.
A person answers every call, day or night. Tell us what got wet and when it started, and we will tell you what happens next.